Program 12 to 15
Xen Topaz Programming Manual 103
PROGRAM 15: EXTENSION BASIC SETUP
15-10: INCOMING VIRTUAL EXTENSION RING TONE ORDER SETUP
Description
Use Program 15-10 : Incoming Virtual Extension Ring Tone Order Setup to set the priority (1-4) for the
Virtual Extension Ring Tones set in Program 15-08. When Virtual Extension calls ring an extension simulta-
neously, the tone with the highest order number (e.g., 1) rings. The other keys just flash.
Input Data
Default
By default, Virtual Extension Ring tones have the following order.
Conditions
None
Feature Cross Reference
♦ Multiple Directory Number / Call Coverage
Telephone Programming Instructions
To enter data for Program 15-10(Incoming Virtual Extension Ring Tone Order Setup):
1. Enter the programming mode.
2. Enter 15 10
3. Enter the number of the item you want to program.
4. Select the Extension number to programmed by pressing the FLASH or the VOLUME▲ or VOLUME▼
keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
IN
SA
SB COPY
Extension Number Max. 4 digits
Order Data Description
Related
Program
1-4
0 : Tone Pattern 1
1 : Tone Pattern 2
2 : Tone Pattern 3
3 : Tone Pattern 4
4 : Incoming Extension ring
tone
In the case of that two or more virtual ex-
tensions are set on a function key on the
keyset, and the tone pattern by which the
sound of each extension differs, the prior-
ity of ring sound is set up.
15-08
Order
Ring Tone
(Set in Program 15-08)
1 0 (Tone Pattern 1)
2 1 (Tone Pattern 2)
3 2 (Tone Pattern 3)
4 3 (Tone Pattern 4)
15-10-01 TEL200
Order1 RG Pttrn0
15-10-xx TELxxxx
xxxxx
To Next Page
Loading...
