NEC Xen Topaz - Extension Control

Program 40 to 92
Xen Topaz Programming Manual 314
PROGRAM 90: MAINTENANCE PROGRAM
90-07: E
XTENSION CONTROL
Description
Use Program 90-07 : Extension Control is used for Extension maintenance.
Input Data
Conditions
None
Feature Cross Reference
None
Telephone Programming Instructions
To enter data for Program 90-07 (Extension Control):
1. Enter the programming mode.
2. Enter 90 07
3. Enter the number of the item you want to program.
4. Select the Menu number to be programmed by pressing the FLASH or the VOLUME▲ or VOLUME▼
keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
IN
SA
SB
Menu Number
1 : Hardware Reset
2 : Software Reset
Extension Number
Up to 4 digits
90-07-01 Menu1
Ext No.
90-07-xx Menux
xxxxx