Xen Topaz Programming Manual 14
Program 10 to 11
PROGRAM 10: SYSTEM CONFIGURATION SETUP
10-02: LOCATION SETUP
Description
Use Program 10-02 : Location Setup to define the location of the installed system. Used for caller ID edit-
ing
.
Input Data
Conditions
None
Feature Cross Reference
♦ Caller ID
Telephone Programming Instructions
To enter data for Program 10-02 (Location Setup):
1. Enter the programming mode.
2. Enter 10 02
3. Enter the number of the item you want to program.
4. Enter data for the item you selected + HOLD.
5. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
Prog. No. Item Input data Default Description Related
Program
10-02-01
Country Code Dial (up to 4
digits)
No setting Enter the country code
10-02-02
International
Access Code
Dial (up to 4
digits)
00 Enter the international ac-
cess code
10-02-03
Other Area
Access Code
Dial (up to 2
digits)
0 Enter the other area access
code. The entered data will
be added in front of received
caller ID for ISDN lines. This
is only valid if PRG 20-19-03
is enabled.
20-19-03
10-02-04
Area Code Dial (up to 6
digits)
No setting Enter the local area code
10-02-05
Trunk Access
Code
Dial (up to 8
digits)
No setting Add Sub Address to S-point
terminal
10-02-06
Country
Selection
0:Australia
1: New Zea-
land
0 Specify the country where
the system is installed.
IN
SA
SB
10-02-01
Country Code
10-02-xx
xxxxx
To Next Page
Loading...
