NEC Xen Topaz - Program 20 - System Option Setup; System Options for Key Telephones

Program 16 to 20
Xen Topaz Programming Manual 115
PROGRAM 20: SYSTEM OPTION SETUP
20-02: S
YSTEM OPTIONS FOR KEY TELEPHONES
Description
Use Program 20-02 : System Options for Multi-Line Telephones to set various system options for Key
Telephones.
Input Data
IN
SA
SB
Prog.
No.
Item
Input Data
Default
20-02-01 Trunk Loop Key Operation
Mode
0 : Indicate the Using Loop Trunk
1 : Not Indicated
0
Mode 0 : Keep
Lamp
1 : Extinction
Incoming 300 IPM Red Blink
Talking Green Light-
ing (On Talk-
ing
TEL)
Extinction
(LED off)
Holding 60 IPM
Green blink
(on Holding
TEL
Extinction
(LED off)
20-02-02 Trunk Loop Access Key Oper-
ating Mode
Use this option to set the operat-
ing mode of the extension’s trunk
group keys. The keys can be for
incoming access, outgoing ac-
cess or both.
0- Outgoing / Incoming
1- Outgoing
2- Incoming
0
20-02-03
-Not Used- -
-
20-02-04 Retrieve the Line After Transfer
Enable (1) or disable (0) an ex-
tension’s
ability to answer a call after it’s
been
transferred, but before it’s an-
swered.
0- Not Holding
1- Holding
1
20-02-05 Headset Busy Mode
Set the conditions under which a
headset extension is busy to in-
coming callers.
0-Disable
1-Enable
0
20-02-06 Preselection Time
When a keyset user preselects a
line key, the system remembers
the preselection for this interval.
0-64800(sec.)
5
20-02-07 Time and Date Display Mode
Set how the Time and Date ap-
pear on
display telephones. There are two
display modes.
1-8
1: (12 hour) TUE 10 3:15PM
5: (24 hour) TUE 10 15:15
1
20-02-08 LCD Display Holding Time 0-64800(sec.)
5