NEC Xen Topaz - Page 123

Program 16 to 20
Xen Topaz Programming Manual 116
PROGRAM 20: SYSTEM OPTION SETUP
20-02: S
YSTEM OPTIONS FOR KEY TELEPHONES
Input Data (Cont)
Conditions
None
Feature Cross Reference
None
Telephone Programming Instructions
To enter data for Program 20-02(System Options for Key Telephones):
1. Enter the programming mode.
2. Enter 20 02
3. Enter the number of the item you want to program.
4. Enter data for the item you selected + HOLD.
5. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
IN
SA
SB
Prog.
No.
Item
Input Data
Default
20-02-09 Disconnect Supervision
Use this option to enable or dis-
able disconnect supervision for
the system
trunks.
0 : Disable
1 : Enable
0
20-02-10 -Not Used-
20-02-11
Default Setting of Microphone of
Key Telephone
0 : Off
1 : On
1
20-02-12 Forced Intercom Ringing
Use this option to enable or dis-
able Forced Intercom Ringing. If
enabled,
incoming Intercom calls
normally ring.
If disabled, Intercom calls
voice-announce.
0 : Disable (Voice)
1 : Enable (Ring)
1
20-02-13
-Not Used-
-
20-02-14
Headset Ringing Cancel Timer 0 - 64800(sec.)
30
20-02-01
TRK Loop Key 0
20-02-xx
xxxxx