NEC Xen Topaz - Trunk Access Code

Xen Topaz Programming Manual 38
Program 10 to 11
PROGRAM 11: SYSTEM NUMBERING
11-09: T
RUNK ACCESS CODE
Description
Use Program 11-09 : Trunk Access Code to assign the trunk access code (normally 0). The trunk access
code can be set from 1 to 4 digits which is defined to type 3 and 4 in Program 11-01. This is the code exten-
sion users dial to access Automatic Route Selection. The Individual Trunk Access Code is used when Trunk
Group Routing is desired for an outgoing line.
Caution
The digit 0 is defined in Program 11-01 as Dial Type 3 with the Number of Digits Required set to 1. If you
change the trunk access code in Program 11-09, you must make the corresponding changes in Program
11-01.
Input Data
Conditions
None
Feature Cross Reference
♦ Automatic Route Selection
♦ Central Office Calls, Placing
♦ Trunk Group Routing
IN
SA
SB
Prog. No. Item Input data Default Description Related Program
11-09-01
Trunk
Access
Code
(for
Type3)
Dial
(Up to 4
digits)
0
Use this program to assign
the trunk access code
(normally 0). This is the
code extension
Users dial to access Auto-
matic
Route Selection.
• 11-01 : System Number-
ing
• 14-01-07 : Trunk Basic
Data Setup
• 14-05 : Trunk Group
• 14-06 : Trunk Group
Routing
11-09-02
Alter-
nate
Trunk
Route
Access
Code
(for
Type4)
Dial
(Up to 4
digits)
No Set-
ting
Use this program to define
additional trunk access
codes.
When a user dials the Al-
ternate Trunk Route
Access Code, the system
routes their call to the Al-
ternate Trunk Route.
• 11-01 : System Number-
ing
• 14-01-07 : Trunk Basic
Data Setup
• 14-05 : Trunk Group
• 14-06 : Trunk Group
Routing
• 21-02 : Trunk Group
Routing for
Extensions
• 21-15: Alternate Trunk
Group Routing
for Extensions