NEC Xen Topaz - EXIFU Hardware Setup

Xen Topaz Programming Manual 27
Program 10 to 11
SYSTEM CONFIGURATION SETUP
10:21: EXIFU H
ARDWARE SETUP
Description
Use Program 10-21 : EXIFU Hardware Setup to set up various hardware, such as the baud rate of COM
port.
Input Data
Conditions
None
Feature Cross Reference
None
Telephone Programming Instructions
To enter data for Program 10-21 (EXIFU Hardware Setup):
1. Enter the programming mode.
2. Enter 10 21
3. Enter the number of the item you want to program.
4. Enter data for the item you selected + HOLD.
5. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section
IN
SA
SB
Prog. No. Item Input Data
Default Description
10-21-01
-Not Used- -
-
-
10-21-02
Baud rate for
COM Port
0 : 4800
1 : 9600
2 : 19200
3 : 38400
4: 57600
5: 115200
5
Define the baud rate of the COM
port within the EXIFU-A1/B1. Sys-
tem must be reset before a
change in setting will take effect.
10-21-02
COM Baud Rate 3
10-21-xx
xxxxx