NEC Xen Topaz - Page 178

Program 21 to 25
Xen Topaz Programming Manual 171
PROGRAM 22: INCOMING CALL SETUP
22-01: S
YSTEM OPTIONS FOR INCOMING CALLS
Input Data (Cont)
Conditions
None
Feature Cross Reference
♦ Central office Calls, Answering
Telephone Programming Instructions
To enter data for Program 22-01 (System Options for Incoming Calls):
1. Enter the programming mode.
2. Enter 22 01
3. Enter the number of the item you want to program.
4. Enter data for the item you selected + HOLD.
5. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
IN
SA
SB
Prog. No. Item Input data Default Description
Related
Program
22-01-10
VRS Waiting
Message Op-
eration
0 : Enable al-
ways
1 : Change by
manual opera-
tion
0 This program set up the op-
eration mode for Auto Atten-
dant and Queuing Message.
22-14
22-15
22-08
22-04
22-01-04
20-15-11
15-07
22-01-11
VRS Waiting
Message Inter-
val Time
0-64800(sec.) 20 Setup the sending duration
time of the Auto - Attendant &
Queuing.
The message is repeatedly
sent out within the specified
time.
22-14-06
22-15-06
22-01-01
ICM Priority 1
22-01-xx
xxxxx