NEC Xen Topaz - Page 177

Program 21 to 25
Xen Topaz Programming Manual 170
PROGRAM 22: INCOMING CALL SETUP
22-01: S
YSTEM OPTIONS FOR INCOMING CALLS
Description
Use Program 22-01 : System Options for Incoming Calls to define the system options for incoming calls.
Input Data
IN
SA
SB
Prog. No. Item Input data Default Description
Related
Program
22-01-01
Incoming Call
Priority
0 : Intercom
Call Priority
1 : Trunk Call
Priority
1 Use this option to determine if
Intercom calls or trunk calls
have answer priority when both
are ringing simultaneously.
22-01-02
Incoming Call
Ring No An-
swer Alarm
0 : Disable
1 : Enable
0 If enabled, an incoming call
that rings longer than the Ring
No Answer Alarm interval (22-
01-03), will change to a unique
ring cadence to indicate that
the call has been ringing too
long. If disabled, this will not
occur.
22-01-03
22-01-04
22-01-03
Incoming Call
Ring No An-
swer Tone
0-64800(sec.) 60 If a trunk rings a key telephone
longer than this interval, the
system changes the ring ca-
dence. This indicates to the
user that the call has been
ringing too long
22-01-02
22-01-04
DIL No Answer
Recall Time/1
st
to second Ring
group
0-64800(sec.) 0 A DIL that rings its pro-
grammed destination longer
than this interval diverts to the
DIL No Answer Ring Group
(set in Program 22-08).
22-01-05
-Not used- - - -
22-01-06
DID Ring-No-
Answer Time
0-64800(sec.) 20 In systems with DID Ring-No-
Answer Intercept, this interval
sets the Ring-No-Answer time.
This interval is how long a DID
call rings the destination exten-
sion before rerouting to the
intercept ring group.
22-12
22-01-07
DID Incoming
Ring Group no
answer timer
0-64800(sec.) 20
22-01-08
DID Pilot Call
No answer
timer
0-64800(sec.) 60
22-01-09
DID to Trunk to
Trunk no an-
swer timer
0-64800(sec.) 20