NEC Xen Topaz - Page 189

Program 21 to 25
Xen Topaz Programming Manual 182
PROGRAM 22: INCOMING CALL SETUP
22-10: DID T
RANSLATION TABLE SETUP
Telephone Programming Instructions
To enter data for Program 22-10 (DID Translation Table Setup):
1. Enter the programming mode.
2. Enter 22 10
3. Enter the number of the item you want to program.
4. Select the Conversion Table Area number to be programmed by pressing the FLASH or the VOLUME
▲
or VOLUME▼ keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
IN
SA
SB
22-10-01C-Area1
1st Start 1
22-10-xxC-Areaxx
xxxxx