NEC Xen Topaz - Page 340

Program 40 to 92
Xen Topaz Programming Manual 333
PROGRAM 92: COPY PROGRAM
92-01: Copy Command
2. Trunk Group Base
3. Extension Base
4. Department Group Base
5. DSS Console Base
IN
SA
SB
Prog. No. Program Name Note
35-03
SMDR Port Assignment for Trunk Group
Prog. No. Program Name Note
15-01
Extension Basic Data Setup (include
Virtual Extension)
Copy all data except extension name(15-01-01)
15-02
Multi-Line Telephone Basic Data Setup
15-03
Single Line Telephone Basic Data Setup
15-06
Trunk Access Map for Extension
15-07
Programmable Function Key
15-08
Incoming Virtual Extension Ring Tone
Setup
15-09
Virtual Extension Ring Assignment
15-10
Incoming Virtual Extension Ring Tone
Order Setup
15-11
Virtual Extension Delayed Ring Assign-
ment
15-12
Conversation Recording Destination for
Extension
20-06
Class of Service for Extension
21-02
Trunk Group Routing for Extensions
21-04
Toll Restriction Class for Extensions
21-11
Hotline Assignment
23-03
Ringing Line Preference
23-04
Ringing Line Preference for Virtual
Extensions
24-03
Park Group Assignment
31-02
Internal Paging Group Assignment
Prog. No. Program Name Note
16-01
Department (Extension) Group Basic
Data Setup
Copy all data except Group Name (16-01-01).
35-04
SMDR Port Assignment for Department
Group
Prog. No. Program Name Note
30-03
DSS Key Assignment