Program 40 to 92
Xen Topaz Programming Manual 334
PROGRAM 92: COPY PROGRAM
92-01: Copy Command
Conditions
Using this program to copy a keyset’s Programmable Function Keys will copy all the keys whether they ex-
ist on the phone to which the programming is being copied. This may cause confusion when trying to define
a key which is already defined but which doesn’t exist on the phone (will display as “DUPLICATE DATA”). It
is recommend to either clear these non-existent keys or to only copy from an extension which has the same
or fewer number of keys than the extension to which the programming is being copied.
Feature Cross Reference
None
Telephone Programming Instructions
To enter data for Program 92-01 (Copy Command):
1. Enter the programming mode.
2. Enter 92 01
3. Enter the number of the item you want to program.
4. Enter data for the item you selected + HOLD.
5. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section
.
IN
SA
SB
92-01-01
Copy Func.
92-01-xx
xxxxx
To Next Page
Loading...
