NEC Xen Topaz - Page 120

Program 16 to 20
Xen Topaz Programming Manual 113
PROGRAM 20: SYSTEM OPTION SETUP
20-01: S
YSTEM OPTIONS
Description
Use Program 20-01 : System Options to set various system options.
Input Data
Conditions
None
Feature Cross Reference
♦ Refer to above chart
IN
SA
SB
Prog.
No.
Item Input data Default Description
Related
Program
20-01-01
Operator Access
Mode
0 : Step
1 : Circular
0 Use this program to set up pri-
ority of a call when calling an
operator telephone.
20-17
20-01-02
Test Message
Mode
0 : Call mode
1 : Absent
mode (Busy
Tone)
0 Use this program to select the
mode when calling the tele-
phone which set up the text
message.
11-11-14
15-07-08
20-01-03
DSP Sender Re-
source Selection
0 : Conference
1 : Caller-ID
2 : MFC
0
20-01-04
-Not Used- - -
20-01-05
DTMF Receive
Active Timer
0-64800(sec.) 10 For OPXs, analogue tele-
phones and certain analogue
trunks (like DISA), the system
attaches a DTMF receiver to
the port for this interval. The
system releases the receiver
after the interval expires.
25-07-01
20-01-06
Alarm Clock Du-
ration
0-64800(sec.) 30 This interval sets the duration
of the alarm signal.
11-11-12
20-01-07
Callback Ring
Duration
0-64800(sec.) 15 Callback rings an extension for
this interval.
11-12-05
15-07-35
20-01-08
Trunk Queuing
Callback Time
0-64800(sec.) 15 Trunk Queuing callback rings
an extension for this interval.
11-12-05
15-07-35
20-01-09
Callback/ Trunk
queuing Cancel
Time
0-64800(sec.) 64800 The system cancels an exten-
sion’s Callback or Trunk Queu-
ing request after this interval.
11-12-05
15-07-35
20-01-10
Trunk Guard
Timer
0-64800(sec.) 1