NEC Xen Topaz - Page 158

Program 21 to 25
Xen Topaz Programming Manual 151
PROGRAM 21: OUTGOING CALL SETUP
21-01:S
YSTEM OPTIONS FOR OUTGOING CALLS
Description
Use Program 21-01 : System Options for Outgoing Calls to set the system options for Outgoing Call
Service.
Input Data
IN
SA
SB
Prog. No. Item Input data Default
Related
Program
21-01-01 Seizure Trunk Line Mode
0 : Route to Priority order
1 : Route to circular
0
14-05
14-06
21-01-02
Intercom Interdigit Time
When placing Intercom calls, ex-
tension users must dial each digit
within this interval.
0-64800(sec.)
10
21-01-03
Trunk Interdigit Time (External)
The system waits for this timer to
expire before placing the call in a
talk state (Call Timer starts after
timer expires, Barge-In are not
allowed until after timer expires).
0-64800(sec.)
10 14-02-08
21-01-04
-Not Used- -
-
21-01-05
-Not Used- -
-
21-01-06
Dial pause at first digit 0-64800(sec.)
3
21-01-07
Toll Restriction Override Time
After dialling the Toll Restriction
Override codes, the system re-
moves Toll Restriction from the
extension for this interval.
0-64800(sec.)
10
21-01-08
Preset dial display hold time 0-64800(sec.)
5
21-01-09
Ringdown Extension Timer
A Ringdown extension automati-
cally calls its programmed desti-
nation after this interval.
0-64800(sec.)
5
21-01-10
Dial Digits for Toll Restriction Path
control
0-36
0
21-01-11
Inter-Digit Time for Toll Restriction
Path control
0-60(sec.)
0
21-01-12 -Not Used-
-
-
21-01-13 -Not Used-
-
-