NEC Xen Topaz - Page 212

Program 21 to 25
Xen Topaz Programming Manual 205
PROGRAM 25: DID/DISA SETUP
25-01: DID/DISA L
INE BASIC DATA SETUP
Description
Use Program 25-01 : DID/DISA Line Basic Data Setup to define the basic setting of each DID/DISA line.
Input Data
Conditions
None
Feature Cross Reference
♦ Direct Inward System Access (DISA)
Telephone Programming Instructions
To enter data for Program 25-01 (DID/DISA Line Basic Data Setup):
1. Enter the programming mode.
2. Enter 25 01
3. Enter the number of the item you want to program.
4. Select the Trunk port number to be programmed by pressing the FLASH or the VOLUME▲ or
VOLUME▼ keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
IN
SA
SB
Trunk Port Number
1-51
Prog. No. Item Input Data
Default Related
Program
25-01-01
DID/DISA Dial-In Mode 0 : Extension number/ Service Code
Specify
1 : Use Dial Conversion Table of
PRG 22-11
0 22-11
25-01-02
DISA User-ID 0 : Off
1 : On
1 25-08
25-01-03
DID/DISA Transfer Alarm 0 : Normal Ringing
1 : Alarm
0
25-01-01TrkPrt1
Dial-In Mode 0
25-01-xxTrkPrtxx
xxxxx