NEC Xen Topaz - Page 239

Program 26 to 35
Xen Topaz Programming Manual 232
PROGRAM 30: DSS/DIL CONSOLE
30-02: DSS C
ONSOLE EXTENSION ASSIGNMENT
Description
Use Program 30-02 : DSS Console Extension Assignment to identify which extensions have DSS Con-
soles assigned.
• You can have up to 9 different DSS Consoles. A single extension can have up to 9 64-Button DSS Con-
soles (9 is the maximum allowed per system).
• Each extension in the system can have one 24-Button DLS Console (72 maximum). An extension can
have a 24-Button DLS Console in addition to 64-Button DSS Consoles.
When programming, each extension/DSS Console combination is called a Console Number.
There are 9 Console Numbers (1-9). You assign Console Numbers to extensions. When entering data, you
normally make the assignment for Console Number 1 first.
Input Data
Conditions
None
Feature Cross Reference
♦ Direct Station Selection (DSS) Console
Telephone Programming Instructions
To enter data for Program 30-02(DSS Console Extension Assignment):
1. Enter the programming mode.
2. Enter 30 02
3. Enter the number of the item you want to program.
4. Select the DSS Console number to be programmed by pressing the FLASH or the VOLUME▲ or
VOLUME▼ keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section
IN
SA
SB
DSS Console Number
The Extension Number for Key Telephone
connected with the DSS Console
Default
Related
Program
1-9
Max. 4 digits
No setting
30-02-01 DSS1
Ext.Number
30-02-xx DSSx
xxxxx