NEC Xen Topaz - Page 25

Xen Topaz Programming Manual 18
Program 10 to 11
PROGRAM 10: SYSTEM CONFIGURATION SETUP
10-03: PCB SETUP
Telephone Programming Instructions
To enter data for Program 10-03 (PCB Setup):
1. Enter the programming mode.
2. Enter 10 03
3. Enter the number of the item you want to program.
4. Select a Slot number to be programmed by pressing the FLASH or the VOLUME
or VOLUME keys.
Or, press FLASH once to select the slot number or press FLASH twice to select a port number.
Enter the slot or port number.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
10-03-01SlotNo
10-03-xxSlotNoxx
xxxxx
IN
SA
SB