NEC Xen Topaz - Page 260

Program 26 to 35
Xen Topaz Programming Manual 253
PROGRAM 33: ANALOGUE INTERFACE SETUP
33-01: A
NALOGUE INTERFACE PORT TYPE SETUP
Description
Use Program 33-01 : Analogue Interface Port Type Setup to set the function of each software port on an
Analogue Communications Interface.
Each Analogue Interface Port can have only one function (input, output or none).
Input Data
Conditions
None
Feature Cross Reference
♦ Analogue Interface Port
Telephone Programming Instructions
To enter data for Program 33-01 (Analogue Interface Port Type Setup):
1. Enter the programming mode.
2. Enter 33 01
3. Enter the number of the item you want to program.
4. Select the Analogue Interface port number to be programmed by pressing the FLASH or the VOLUME▲
or VOLUME▼ keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
IN
SA
SB
Analogue Interface Port
Number
Analogue Interface Port Type
Default
Related
Program
1-6
0 : No setting
1 : Input
2 : Input/Output
3 : BGM Input
4 : EXMOH Input
0
33-01-01ACIPort1
ACI Type 0
33-01-xx ACIPortx
xxxxx