Xen Topaz Programming Manual 20
Program 10 to 11
PROGRAM 10: SYSTEM CONFIGURATION
10-06: ISDN BRI S
ETUP
Description
Use Program 10-06 : ISDN BRI Setup defines the TEI selection and DID mode for DID callers when the
BRI feature is used. Previously, if the called party number did not match the SPID number, the system
would not allow the call to go through. And to enter the SPID (Service Profile ID) assigned to each of the
system’s BRI ISDN lines. Each BRI PCB has a maximum of two lines and each line can have a maximum
of two SPIDs.
To use both channels of a BRI ISDN line, two directory numbers must be ordered from telco. A SPID will be
assigned for each directory number.
Input Data
Conditions
None
Feature Cross Reference
♦ ISDN Compatibility
SLOT No. 5,6
ISDN Line No.
1-4
Prog.
No.
Item Input Data Default Description
10-06-01 TEI selection
0 : Select by SPID number
1 : Select by Channel ID Num-
ber
0
10-06-02 DID mode
0 : Route by Called Party Num-
ber
1 : Route by Redirecting Num-
ber
0
10-06-03 SPID1
Dial (Up to 20 digits) No setting
10-06-04 SPID2
IN
SA
SB
To Next Page
Loading...
