NEC Xen Topaz - Page 31

Xen Topaz Programming Manual 24
Program 10 to 11
PROGRAM 10: SYSTEM CONFIGURATION SETUP
10-12: EXIFU N
ETWORK SETUP
Description
Use Program 10-12 : EXIFU Network Setup to setup the IP Address, Subnet-Mask, and Default Gateway
addresses of EXIFU.
Conditions
System must be reset before a change to the IP Address or subnet mask will take effect.
Feature Cross Reference
♦ VoIP
IN
SA
SB
Prog. No. Item Input Data Default Condition
10-12-01
IP Ad-
dress
0.0.0.0 - 126.255.255.254
128.0.0.0 - 191.254.255.254
192.0.0.0 - 223.255.254.254
172.16.0.10
10-12-02
Subnet
Mask
128.0.0.0 192.0.0.0 224.0.0.0
240.0.0.0 248.0.0.0 252.0.0.0.
254.0.0.0 255.0.0.0 255.128.0.0
255.192.0.0 255.224.0.0 255.248.0.0
255.252.0.0 255.254.0.0 255.255.0.0
255.255.128.0 255.255.192.0 255.255.224.0
255.255.248.0 255.255.252.0 255.255.254.0
255.255.255.0 255.255.255.128 255.255.255.192
255.255.255.224 255.255.255.240 255.255.255.248
255.255.255.252 255.255.255.254 255.255.255.255
255.255.0.0
The setting of Subnet-
Masks are incorrect
when all Host
Addresses are 0.
If the network section
is;
0,
127
128.0
191.255
192.0.0
223.255.255
The setting of Sub-
Net-Mask is incorrect.
10-12-03
Default
Gateway
0.0.0.0 - 126.255.255.254
128.0.0.0 - 191.255.255.254
192.0.0.0 - 223.255.255.254
0.0.0.0 IP Address for Router
10-12-04
Time
Zone
0 to 24 which is equivalent to –12 thru +12 Hours 12
10-12-05
NIC
0 : Auto Detect
1 : 100Mbps, Full Duplex
2 : 100Mbps, Half Duplex
3 : 10Mbps, Full Duplex
4 : 10Mbps, Half Duplex
0 NIC Auto Negotiate
10-12-06
NAT
Router
0 : Not Used
1 : Use
0
Connect NAT Router
or not.
10-12-07
Default
Gateway
(WAN)
0.0.0.0 - 126.255.255.254
128.0.0.0 - 191.255.255.254
192.0.0.0 - 223.255.255.254
0.0.0.0
IP Address for Router
(WAN side)