Xen Topaz Programming Manual 50
Program 10 to 11
PROGRAM 11: SYSTEM NUMBERING
11-16: O
NE-DIGIT SERVICE CODE SETUP
Description
Use Program 11-16 : One-Digit Service Code Setup to customize the one-digit Service Codes used when
a busy or ring back signal is heard. You can customize additional Service Codes in Programs 11-10 through
11-15.
The following chart shows:
• The number of each code (01-10)
• The function of the Service Code.
• What type of telephones can use the Service Code
• The code’s default entry. For example, dialling 1 (code 03) when calling an extension will switch the call
from either a voice or signal call (depending on how it’s currently defined).
• Programs that may be affected by changing these codes.
Input Data
Conditions
None
Feature Cross Reference
Refer to chart above
Telephone Programming Instructions
IN
SA
SB
Prog. No. Item Terminals Default
Related
Program
11-16-01
Step Call (Busy + No Answer)
KTS,SLT 2
11-16-02
Barge-In
KTS,SLT No setting
11-16-03
Switching of Voice/ Signal Call
KTS,SLT 1
11-16-04
Intercom Off Hook Signalling
KTS,SLT *
11-16-05
Camp-On
KTS,SLT 0
11-16-06
DND/Call Forward Override
KTS,SLT No setting
11-16-07
Message Waiting
KTS,SLT No setting
11-16-08
-Not Used- -
-
11-16-09
Access to Voice Mail
KTS,SLT No setting
11-16-10
STG All Ring Mode
KTS,SLT No setting 16-01-05
To Next Page
Loading...
