NEC Xen Topaz - Page 96

Program 12 to 15
Xen Topaz Programming Manual 89
PROGRAM 15: EXTENSION BASIC SETUP
15-02: M
ULTI-LINE TELEPHONE BASIC DATA SETUP
Input Data (Cont)
IN
SA
SB COPY
Prog. No. Item Input data Default
Related
Program
15-02-11
Callback Automatic Answer
Use this option to enable or disable
automatic answer for Callback.
If enabled, extension automatically
Answers Callback ringing when user
lifts the Handset.
If disabled, user must press line ap-
pearance key to answer Callback.
0 : Off
1 : On
1
15-02-12
Off Hook Signaling
Use this option to set the keyset’s
Off Hook Signaling. Off Hook Signal-
ing occurs when a keyset user re-
ceives a second call while busy on the
Handset Call. To enable/disable Off
Hook Signaling for an extension’s
Class of Service
0 : Muted Off Hook Ring-
ing
1 : No Off Hook Ringing
2 : Not Used
3 : 1 beep tone on
Speaker
4 : 1 beep tone on Hand-
set
0
15-02-13
Redial List Mode
Select whether the Redial List feature
should store internal and external
numbers (0), or only external numbers
(1).
0 : Extension/Trunk Mode
1 : Trunk Mode
1
15-02-14
-Not Used- -
-
15-02-15
Storage of Caller-ID for answered
call
0 : Disable
1 : Enable
1
15-02-16
Handsfree Operation
0 : Disable
1 : Enable
1
15-02-17
-Not Used-
-
-
15-02-18
-Not Used-
-
-
15-02-19
-Not Used-
-
-
15-02-20
-Not Used-
-
-
15-02-21
Virtual Extension Access Mode
(when idle Virtual Extension Key
pressed)
Determine whether an extension’s
Virtual Extension/Call Coverage
Key should be for placing and
receiving calls (0), or just receiving
incoming calls (2).
0 : DSS (Inbound/
Outbound)
1 : Outgoing
2 : Ignore Key (Inbound)
2
15-02-22
Multiple Incoming Call from Inter-
com and Trunk
0 : Disable
1 : Enable
1
15-02-23
Abbreviated dial Preview Mode
Use this function to control the func-
tion of the extension’s DC key. The
DC key can be set to preview ABB
dial numbers or dial out immediately.
0 : Preview
1 : Outgoing immediately
0