910-269-EN, Rev. B, June 2011
Managing Special Waveform Functions (Conventional UT Mode) 105
•Data logger
•Printing
When freeze function is active, the following parameters cannot be changed/accessed:
•Zero offset
• Range (cannot be increased)
• Pulser/Receiver settings other than gain
5.5 Grid Modes
The EPOCH 1000 Series provides multiple grid modes for easy A-scan interpretation,
depending on the application.
To adjust the grid modes
1. Choose 3/5 > Display Setup > A-Scan Setup to open the A-Scan setup page.
2. Move the focus to the X-Axis grid Mode parameter using the [UP] and [DOWN]
arrow keys (see
Figure 5-3 on page 106).
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
