Olympus EPOCH 1000 Series - Figure 16-2 Cursors on S-Scan with Measurement; Cursor Measurements

910-269-EN, Rev. B, June 2011
Image-Sizing Cursors (Phased Array Mode) 273
16.4 Cursor Measurements
The EPOCH 1000 Series image-sizing cursors allow four main types of measurements
that you can select from the Reading Setup setup page accessible by choosing 3/5
>
Meas Setup
> Reading Setup. You can select the following cursor measurements:
X2 - X1
The horizontal distance between X cursors.
Y2 - Y1
The vertical distance between Y cursors.
CursorX1, CursorY1 Intersect Amplitude
The signal amplitude at the intersection point of X1 and Y1.
CursorsX1, CursorY1 Intersect Depth
The thickness/TOF measurement of the signal at the intersect point of X1 and Y1.
Figure 16-2 Cursors on S-scan with measurement
Downloaded from ManualsNet.com search engine