910-269-EN, Rev. B, June 2011
Gates (Conventional UT Mode) 113
4. Use the [RIGHT] or [LEFT] arrow keys to scroll between gate start, width, and
level of the selected gate.
5. Edit the value of the selected gate parameter.
When adjusting a gate using the direct-access [GATE] key, the previous selected
submenu does not change. This allows you to make fast adjustments to the gate
position and immediately return to the parameter of the previous operation.
6.3 Interface Gate (Optional)
The EPOCH 1000 Series features an optional interface gate, providing a third
measurement gate. The interface gate positioning is controlled using the same two
methods as described in
6.1 on page 110 and 6.2 on page 112 for measurement gates 1
and 2.
For further information about special interface gate functions, see section 11.5 on
page 234.
6.4 Gate Measurement Modes
The EPOCH 1000 Series’ gate 1 and gate 2 provide measurements of a gated
indication based on one of three possible measurements modes. You can define the
measurement mode of each gate in the Gates setup page (shown in
Figure 6-4 on
page 114) accessible by choosing 2/5 > Gate Setup > Setup.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
