910-269-EN, Rev. B, June 2011
178 Chapter 10
Figure 10-1 The Create setup page
2. In the Create setup page, choose File, and then enter a file name up to 8 characters
long using the virtual keyboard or a USB keyboard.
3. Optionally enter information for the following parameters:
a) Choose Description, and then enter a file description.
b) Choose Inspector ID, and then enter identification information for the
inspector.
c) Choose Location Note, and then enter information regarding the inspection
location.
4. Choose the desired file type tab (CAL in the example shown in Figure 10-1 on
page 178). For more information on available file types, see section 10.3.6 on
page 185.
5. Complete all required file type parameters.
6. Once you have completed file setup, choose Create to exit the setup page and
create the desired file.
File type tab
File type
parameters
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
