Olympus EPOCH 1000 Series - Cursor Positioning; Figure 16-1 Cursors and S-Scan During Adjustment

910-269-EN, Rev. B, June 2011
272 Chapter 16
16.3 Cursor Positioning
Each cursor set has two measurement cursors. This allows cursor-to-cursor
measurements in the horizontal (X) and vertical (Y) directions.
To position image-sizing cursors on the display
1. Press [FREEZE] to activate freeze.
2. Select 1/5 > PA Cursors > Cursor X = On and Cursor Y = On.
3. Choose 1/5 > PA Cursors > Cursor X1, Cursor X2, Cursor Y1, and Cursor Y2
parameters to adjust cursor-position values.
Figure 16-1 Cursors and S-scan during adjustment
The image-sizing cursors cannot be positioned beyond the visible screen range. Also,
Cursor X2 or Cursor Y2 cannot be positioned before Cursor X1 or Cursor Y1,
respectively.
Downloaded from ManualsNet.com search engine