Olympus EPOCH 1000 Series - Peak Memory; Peak Hold

910-269-EN, Rev. B, June 2011
262 Chapter 14
The reject function can be used in RF display mode.
The reject level is displayed as a horizontal line (or two lines in the case of the RF
display mode) on the A-scan display only. In the S-scan view mode, it is not
possible to identify that reject is active.
14.5 Peak Memory
The peak memory feature in the EPOCH 1000 Series phased array mode applies only
to the selected A-scan display (current focal law).
For a full description of the peak memory function, refer to section 5.2 on page 102.
14.6 Peak Hold
The peak hold feature in the EPOCH 1000 Series phased array mode applies only to
the selected A-scan display (current focal law).
For a full description of the peak hold function, refer to section 5.3 on page 104.
Downloaded from ManualsNet.com search engine