Olympus EPOCH 1000 Series - Figure 17-8 a Completed Wedge Delay Calibration

910-269-EN, Rev. B, June 2011
Calibrating the EPOCH 1000 Series (Phased Array Mode) 285
11. Choose 1/5 > PA Cal > Done to accept the drawn line and to calculate the wedge
delay.
Figure 17-8 A completed wedge delay calibration
When using a side-drilled hole to calibrate wedge delay, it is necessary to move
the probe across the side-drilled hole to acquire a thickness measurement for all
focal laws.
Downloaded from ManualsNet.com search engine