910-269-EN, Rev. B, June 2011
28 Chapter 1
1.4.1 Conventional Transducer Connections
The EPOCH 1000 Series instruments are supplied with either BNC or LEMO 01
conventional transducer connectors. The type of conventional transducer connector is
chosen at the time of order. If necessary, it is possible to change the type of transducer
connection at an authorized Olympus service center for a small charge. Selection of
these transducer connections is based on operator preference. Both the BNC and
LEMO
01 connectors available are rated to IP67 for use in most inspection
environments. The EPOCH
1000 Series is illustrated with BNC connectors in this
document.
The conventional transducer connectors are located at the top of the instrument on the
left. The two connectors are easily accessible from the front of the instrument (see
Figure 1-7 on page 28).
Figure 1-7 Location of the conventional transducer connectors
For single-element transducers, either transducer connector may be used. For some
dual transducer and for through-transmission inspections, the transducer connectors
are labeled T/R and R. T/R should be used as the transmit channel, and R should be
used as the receive channel in these situations.
Warning symbol
Transmit/Receive BNC connector
(LEMO 01 also available)
Receive only BNC connector
(LEMO 01 also available)
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
