910-269-EN, Rev. B, June 2011
Gates (Conventional UT Mode) 111
Figure 6-2 The Gate 1 submenu
The available gate parameters are:
Zoom
Used to zoom the display on the width of the gate (refer to section 6.8 on page 119
for details).
Start
Used to adjust the gate start position.
Width
Used to adjust the gate width.
Level
Used to adjust the vertical position of the gate.
Alarm
Used to select a gate alarm condition (refer to section 6.9 on page 120 for details).
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
