910-269-EN, Rev. B, June 2011
72 Chapter 3
Reading 1 to 6
Each measurement reading box is defined independently when in manual mode.
Below the reading selection parameters, an example of the measurement reading
boxes is displayed to illustrate the position of the measurement being adjusted
(see Figure 3-17 on page 71). Table 22 on page 72 presents the available
measurement readings.
Figure 3-18 Example of measurement reading boxes with icons
Table 22 Available measurement readings
Icon Measurement readings Description
Gate 1 Thickness Thickness in gate 1. Not used with Angle.
Gate 2 Thickness Thickness in gate 2. Not used with Angle.
IF Gate Thickness Thickness in IF gate. Not used with
Angle.
Gate 1 Sound Path Distance Sound path (Angular) distance in gate 1.
Gate 2 Sound Path Distance Sound path (Angular) distance in gate 2.
Gate 1 Depth to Reflector Depth to reflector in gate 1. Used with
Angle.
Gate 2 Depth to Reflector Depth to reflector in gate 2. Used with
Angle.
Gate 1 Surface Distance Horizontal distance to reflector in gate 1.
Used with Angle.
Gate 2 Surface Distance Horizontal distance to reflector in gate 2.
Used with Angle.
Gate 1 Surface Distance –
X Value
Horizontal distance minus X-Value
(distance from beam index point to front
of wedge) in gate 1. Used with Angle.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
