910-269-EN, Rev. B, June 2011
EPOCH 1000 Series Hardware Features 29
Do not touch the inner conductor of the BNC (or LEMO) connectors to avoid risks
of an electrical shock. Up to 475 V can be present on the inner conductor. The
warning symbol between the Transmit/Receive (T/R) and the Receive (R) BNC
connectors shown in Figure 1-7 on page 28 indicates this electrical shock risk.
1.4.2 Phased Array Transducer Connector (EPOCH 1000iR/1000i Only)
The EPOCH 1000iR and EPOCH 1000i come standard with one phased array
transducer connector located at the back of the instrument (see
Figure 1-8 on page 29).
This connector is also used with other Olympus products, including the OmniScan
instruments. Any phased array transducer with element count matching the
capabilities of the EPOCH
1000 Series may be used with this standard connector.
Refer to section
19.4 on page 318 for specifications of compatible PA probes.
Figure 1-8 The connector for the phased array (PA) probe
Phased array connector
Phased array transducer connector
Spring loaded screws
Alignment pin
(second hidden)
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
