910-269-EN, Rev. B, June 2011
EPOCH 1000 Series Hardware Features 31
Figure 1-9 Phased array connection cover
1.4.3 Input/Output Connectors
The ALARMS and the ANALOG OUT connectors are located at the back of the
instrument, in the upper-right corner (see
Figure 1-10 on page 32). A rubber cover
protects each connector. The connectors provide analog outputs, digital alarm
outputs, a digital input, and encoder outputs. Refer to section
19.3 on page 316 for the
complete specifications of the supported I/O signals.
Protective cover over the phased
array connector
Alternative location for the
protective cover
Thumb screws (2)
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
