Olympus EPOCH 1000 Series - Leg Indicators; Figure 14-8 S-Scan with the Probe Front Cursor Active

910-269-EN, Rev. B, June 2011
Managing Phased Array Image Display 265
Figure 14-8 S-scan with the probe front cursor active
14.8.2 Leg Indicators
When a part thickness is defined in the Beam setup page (see chapter 12 on page 239),
the instrument draws (multiple) horizontal line(s), depending on the overall
inspection range, to visually indicate the part thickness on the S-scan image. These
lines correspond to the part thickness on the vertical (depth) axis of the S-scan image.
Probe front
cursor (vertical
white line)
Downloaded from ManualsNet.com search engine