910-269-EN, Rev. B, June 2011
EPOCH 1000 Series Software Features 79
3.3.6 Status Setup Page
The Status setup page, shown in Figure 3-21 on page 79, is accessible by choosing
3/5 > Inst Setup > Status. The page provides information about the current status of
the instrument such as the internal temperature, battery state as well as instrument
hardware/software identification data.
Figure 3-21 The Status setup page
The Status page allows you to enter a activate code to allow access to a software
option not included with the standard package of instrument features. This is
provided by an Olympus representative after the purchase of a particular software
option. Refer to section
11.1 on page 195 for details on software option activation.
3.3.7 Display Setup Page (Phased Array Mode Only)
The Display setup page, shown in Figure 3-22 on page 80, is accessible by choosing
3/5 > Display Setup > Image Overlay. The page allows you to activate overlays to the
S-scan view.
Enter software
option activation
code here
Software serial
number
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
