910-269-EN, Rev. B, June 2011
52 Chapter 3
Each menu contains up to five submenu buttons appearing vertically on the right side
of the software main display. The submenu buttons of only one menu appear at a
given time on the software main display. Use the corresponding [F<n>] function key,
the arrow keys, or the adjustment knob to select a submenu.
Seven parameter buttons, associated with the selected submenu button, appear
horizontally at the bottom of the software main display. Press the corresponding
[P<n>] parameter key or the arrow keys to select a parameter.
Section 3.2 on page 61 provides a complete and quick reference to all menus,
submenus and parameters available in both the UT and PA operation modes.
3.1.2 About the Convention to Identify Menu Elements
In this document, the following convention is used to concisely refer to an element in
the menu structure:
Menu > Submenu > Parameter = value
where:
Menu is replaced by the value of the menu indicator (ex.: 3/5)
Submenu is replaced by the label of the submenu (ex.: Meas Setup)
Parameter is replaced by the label of the parameter (ex.: Unit)
Value is replaced by the desired editable or selectable value (ex.: mm)
For example, to instruct you to set the Unit parameter to mm, in the Meas Setup
submenu of the third menu, the expression shown in
Figure 3-4 on page 53 is used.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
