910-269-EN, Rev. B, June 2011
Software Features and Options (Conventional UT Mode) 203
Figure 11-6 on page 203 shows a DAC curve after 5 points have been acquired. In this
example, every point was automatically adjusted to 80 % FSH prior to capture.
Figure 11-6 DAC Setup five points
If you need to continue capturing points, you may increase the instrument range
or increase the display delay to view echoes further out in time.
Once the correct number of points have been captured, choose 6/6 > DAC Setup >
Done to complete the DAC curve and switch to the DAC inspection mode.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
