910-269-EN, Rev. B, June 2011
Managing the Data Logger 185
10.3.6 Data File Types
The EPOCH 1000 Series supports two file types. These files allow storage of
calibration data or standard inspection data. Each file type appears as a separate tab
in the Create setup page, accessible by choosing 5/5 > Files
> Create.
Figure 10-5 The Create setup page with the INC file type tab selected
Each file type has a unique set of setup items. Not all items are mandatory to properly
set up a file for data storage.
The following sections describe each file type in detail. In each section, a list of
mandatory and optional fields is provided to aid in file setup.
10.3.6.1 Calibration File
A CAL file is designed for storage of instrument setups (calibrations). These files can
only contain one saved ID at a time. This allows you to rapidly recall an instrument
setup, either from the data logger submenu, or by using the [RECALL SETUP] button
on the instrument keypad.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
