910-269-EN, Rev. B, June 2011
Powering the EPOCH 1000 Series 41
When a phased array probe is connected to the EPOCH 1000 Series, the instrument
automatically detects it and completes the startup process by opening the Beam setup
page, allowing you to validate probe parameters (see
Figure 2-2 on page 41). Refer to
section 12.2 on page 240 for details on the Beam setup page. Press [ESCAPE] to save
and close the Beam setup page.
Figure 2-2 The Beam setup page appearing at startup when a PA probe is connected
2.2 Using the AC Line Power
AC line power is supplied to the EPOCH 1000 Series instrument via the
charger/adaptor (PN: EP-MCA). The EP-MCA has a universal AC power input, so it
operates with any line voltage from 100–120
VAC or 200–240 VAC and with 50 Hz to
60
Hz line frequency. The charger/adaptor output connects to the AC adaptor plug of
the EPOCH
1000 Series instrument (see Figure 2-3 on page 42).
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
