Olympus EPOCH 1000 Series - Page 348

910-269-EN, Rev. B, June 2011
336 List of Figures
Figure 11-14 Completed custom DAC ................................................................................. 212
Figure 11-15 Completed 20-80 DAC .................................................................................... 213
Figure 11-16 Completed TVG table with table view ......................................................... 216
Figure 11-17 TVG table being set up .................................................................................... 218
Figure 11-18 A-scan inspection with TVG table (table view off) ..................................... 219
Figure 11-19 DGS/AVG setup page ...................................................................................... 221
Figure 11-20 Reference-reflector before capture ................................................................ 224
Figure 11-21 DGS/AVG curves on the screen ..................................................................... 225
Figure 11-22 Gain curve adjusted DGS ............................................................................... 227
Figure 11-23 Reference B being stored ................................................................................. 231
Figure 11-24 Active AWS with D rating .............................................................................. 232
Figure 11-25 Active IF gate with IF Gate submenu ........................................................... 234
Figure 11-26 Floating gate setup page ................................................................................. 236
Figure 11-27 Indication using –6 dB floating gate ............................................................. 237
Figure 11-28 Indication using –14 dB floating gate ........................................................... 238
Figure 12-1 The Beam setup page ...................................................................................... 240
Figure 12-2 S-scan image 40°–70° with 4 in. sound path ................................................ 241
Figure 12-3 The Edit Probe setup page .............................................................................. 245
Figure 13-1 A/S Vert view with Video Filter set to Off (left) and to Low (right) ......... 250
Figure 14-1 The four display view modes ......................................................................... 254
Figure 14-2 A-scan and S-scan with the focal law cursor and the angle parameter
box ...................................................................................................................... 256
Figure 14-3 S-scan example with the color palette .......................................................... 257
Figure 14-4 The color and the grey scale palettes ............................................................ 258
Figure 14-5 S-scan showing the location of visible defects ............................................. 259
Figure 14-6 Best fit off and on ............................................................................................. 260
Figure 14-7 Display setup page .......................................................................................... 264
Figure 14-8 S-scan with the probe front cursor active ..................................................... 265
Figure 14-9 S-scan with the leg indicators active ............................................................. 266
Figure 14-10 A-scan and S-scan in Grey Scale mode with indication ............................. 267
Figure 15-1 A-scan and S-scan with viewable gate .......................................................... 270
Figure 16-1 Cursors and S-scan during adjustment ........................................................ 272
Figure 16-2 Cursors on S-scan with measurement .......................................................... 273
Figure 17-1 Example of gated calibration signal .............................................................. 279
Figure 17-2 The Enter Value for Thin Standard dialog box ............................................ 280
Figure 17-3 Example of the second gated calibration signal .......................................... 281
Figure 17-4 The Enter Value for Thick Standard dialog box .......................................... 281
Figure 17-5 Example of gated calibration signal .............................................................. 282
Figure 17-6 The Enter Value for Zero Cal dialog box ...................................................... 283
Figure 17-7 The Wedge Delay acquisition screen with thickness measurement
reading at the top ............................................................................................. 284
Figure 17-8 A completed wedge delay calibration .......................................................... 285
Downloaded from ManualsNet.com search engine