Olympus EPOCH 1000 Series - Page 359

910-269-EN, Rev. B, June 2011
Index 347
keyboard, USB 27
keypad 24
direct access 21
key description 25
versions 25
knob 21, 22
L
label, rating plate 2
leading zeroes for instrument increment, note
187
[LEFT] key 22
leg grid mode 107
leg indicator 265
LEMO 01 connector 4, 28
locating beam index point (BIP) 154
LOS loss of signal 257
LW longitudinal wave 318
M
managing
data with GageView Pro 86
special waveform functions 101
manual TVG setup 214
markers 59
material geometry 242
Meas setup menu 71
measurement gates 1 and 2 110
measurements
echo-to-echo 116
gate tracking 116
specifications 315
measurements readings 72
membrane
seals 36
vent 20
membrane vent
battery compartment vent 33
metric units, note 137, 140, 145, 150, 157, 163,
278
minimum depth alarm 121
gate tracking 122
setting 122
single gate 121
mode
display view 253
models, instrument 14
mouse, USB 27
N
NAVSHIPS cylindrical reflector block 172
negative value, cursor-to-gate, note 126
note
A and C accuracy 233
acquisition for all focal laws 298
AcvSpecimen and AcvCalBlock 223
angle beam application, angle beam applica-
tion, note 261
auto-calibration and single thickness test
block 145
auto-calibration scope 133
AUTO-XX% activation 90
AUTO-XX% usage 90
battery and transducer life 249
battery complete charge/discharge cycles 43
battery maximize life 93
beam parameter calculation 244
best fit feature 260
capturing back-wall echoes 151
D indication rating 233
interpretation 233
DGS/AVG curve gain adjusting 226
DGS/AVG sizing technique advantage 227
display modes 254
disregard beam spreading echo 159
dual transducer and non-linear thickness
measurement 146
exit with cancel box 139, 143, 148, 153, 159,
165, 280, 292
filter set and EN12668-1 99
first back-wall echo 142
floating gate and RF mode 238
gain coarse adjustment 91
gain curve saturation 288, 301
[GATE] key and previous group menu 113
[GATE] key for current gate only 112
horizontal ruler and front of wedge 261
immersion scanning with interface gate 214
indication in gate 116
leading zeroes for instrument increment 187
metric units 137, 140, 145, 150, 157, 163,
278
Downloaded from ManualsNet.com search engine