910-269-EN, Rev. B, June 2011
70 Chapter 3
The available parameters are:
Live A-Scan Display
Used to set the live A-scan drawing mode:
•Outline
• Filled
Envelope Display
Used to set the peak memory and peak hold A-scan envelope drawing mode:
•Outline
• Filled
X-Axis Grid Mode
Used to set the horizontal X-Axis grid display mode:
Off: no grid
Standard: 10 divisions spaced evenly and labeled 1 to 10
Soundpath: five divisions spaced evenly and labeled with corresponding sound
path values
Leg: up to four divisions representing half-skip distances in angle beam
inspection mode, based on test piece thickness value, and labeled L1 to L4
Y-Axis Grid
Used to set the vertical Y-axis grid display mode to either 100 % or 110 % full-
screen height.
Baseline Break
Used to turn this feature on or off.
Ascan
Used to select the A-scan mode (Single or MultiLaw). When MultiLaw is
selected, angles for three A-scans can be selected.
Angle AScan 1, 2, or 3
Used to set the angle for three A-scans in MultiLaw mode.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
