Panasonic VR2 Series - Weld Commands（Low Pulse MIG; Lpdelay; Lpduty; Lpfrq

16-25
16-6. Weld commands（Low pulse MIG）
16-6-1. LPDELAY
Format
LPDELAY [Value]
Function It finely adjusts low pulse start time. Value Fine time adjustment
Condition [0.5 - 10.0] Hz
Lock condition Arc lock (Internal execution).
Syntax check None.
Example Set the fine time adjustment to +1.
LPDELAY +1
The same command in
conventional models

16-6-2. LPDUTY
Format
LPDUTY [Value]
Function It sets the low pulse duty. Value Low pulse duty [10 – 90]%
Condition
Lock condition Arc lock (Internal execution).
Syntax check None.
Example Set the low pulse duty to 50%.
LPDUTY 50
The same command in
conventional models

16-6-3. LPFRQ
Format
LPFRQ [Frequency]
Function It sets low pulse frequency. Frequency Low pulse frequency
Condition [0.5 - 10.0] Hz
Lock condition Arc lock (Internal execution).
Syntax check None.
Example Set the low pulse frequency to 2.0.
LPFRQ 2.0
The same command in
conventional models

16-6-4. LPLEVEL
Format
LPLEVEL [Value]
Function It sets the low pulse level. Value
Low pulse level [−50 – 0]
Condition
Lock condition Arc lock (Internal execution).
Syntax check None.
Example Set the low pulse level to –25%.
LPLEVEL -25
The same command in
conventional models
16-6-5. LPLS
Format
LPLS [ON/OFF]
Function It turns on or off low pulse control. ON/OFF Low pulse control
Condition
Lock condition Arc lock (Internal execution).
Syntax check None.
Example Start the low pulse control.
LPLS ON
The same command in
conventional models