Panasonic VR2 Series - Fttlvl; Gasvalve; Hotcur; Hotvlt

16-16
16-5-9. FTTLVL
Format
FTTLVL [Value]
Value Fine adjustment value which will
be added to the system set value.
[-50 - +50]
Function It adjusts the FTT voltage level.
Increase the value to round the end of the wire.
As a result it reduces chances of the wire stick.
Decrease it to sharpen the end of the wire for
better arc start.
* Executing +1 adjustment twice
does not result in +2.
Condition Weld package.
Lock condition Arc lock (Internal execution).
Syntax check None.
Example Adjust the system set value by +1.
FTTLVL +1
The same command in
conventional models
FTTLVL
16-5-10. GASVALVE
Format
GASVALVE [ON/OFF]
Function It opens or closes the gas valve. ON/OFF ON to open the gas valve.
Condition Weld package. OFF to close the gas valve.
Lock condition Arc lock.
Syntax check None.
Example Open the gas valve.
GASVALVE ON
The same command in
conventional models
OUTB OPORT#210=*
16-5-11. HOTCUR
Format
HOTCUR [Value]
Function It adjusts Hot current. Value
Adjustment value [−3 - ＋3]
Condition
Lock condition Arc lock
Syntax check None
Example Set the Hot current to +1.
HOTCUR +1
The same command in
conventional models

16-5-12. HOTVLT
Format
HOTVLT [Value]
Value Fine adjustment value which will
be added to the system set value.
[-50 - +50]
Function It adjusts the hot voltage.
Increase the value to smoothen wire feeding
immediately after the arc start.
Decrease it to restrain the burn-back immediately
after the arc start.
* Executing +1 adjustment twice
does not result in +2.
Condition Weld package.
Lock condition Arc lock (Internal execution).
Syntax check None.
Example Adjust the system set value by +1.
HOTVLT +1
The same command in
conventional models
HOTVLT