Panasonic VR2 Series - Snssft-Off; Snssft-On; Snssftrst; Snssftsv

16-40
16-13-2. SNSSFT-OFF
Format
SNSSFT-OFF
Function It terminates sensor shift
Condition Standard.
Lock condition None.
Syntax check None.
Example Terminate sensor shift.
SNSSFT-OFF
The same command in
conventional models
SFTBUF=0
16-13-3. SNSSFT-ON
Format
SNSSFT-ON
Function It starts sensor shift
Condition Standard.
Lock condition None.
Syntax check None.
Example Start sensor shift.
SNSSFT-ON
The same command in
conventional models
SFTBUF=1
16-13-4. SNSSFTRST
Format
SNSSFTRST
Function It clears the sensor shift amount.
Condition Standard.
Lock condition None.
Syntax check None.
Example Reset sensor shift amount.
SNSSFTRST
16-13-5. SNSSFTSV
Format
SNSSFTSV [Variable]
Function It stores the current sensor shift amount to the
specified variable.
Variable Shift amount (GD)
Condition Standard.
Lock condition None.
Syntax check Error if variable types do not match.
Example Store the sensor shift to GD001.
SNSSFTSV GD001
The same command in
conventional models
RSTBUF
16-13-6. TCHSNS
Format
TCHSNS SPD= [Speed]
Function It starts touch sensing Speed Sensing speed in m/min.
Condition Standard.
Lock condition None.
Syntax check None.
Example Start touch sensing at speed 0.5 m/min.
TCHSNS SPD=0.5
The same command in
conventional models
TCHSNS
Note
The result of the touch sensing (shift amount) is stored in the sensor shift amount.