Panasonic VR2 Series - Unification;Individual; Weld Conditions; Inching Speed

15-11
15-2-4. Unification/Individual
It specifies how you want to set welding conditions.
Unification/
Individual
Î
[Unification]
Adjusts welding automatically according to
the welding table by setting welding current.
[Individual] Sets the welding current and voltage
separately.
15-2-5. Weld conditions
Welding conditions can be set easily by selecting a set of conditions preset in the weld condition table if the table is
previously prepared.
Weld
condition
Î
It is possible to register up to 50 sets of welding
conditions in the table.
Table No.1 to 5
: Appropriate set values for each
welding method are automatically set.
Table No.6 to 50
: Open to users’ settings.
[ARC-SET]
Specifies welding conditions at arc start.
[CRATER] Specifies welding conditions at crater
welding (i.e. at arc end)
15-2-6. Inching speed
It is to set the speed of wire inching when operated using the teach pendant.
Inching
speed
Î
[High] Specifies the inching speed 3 seconds after
inching start. [Set range: 1 to +255]
(Coefficient. Set large number for higher speed.)
[Low] Specifies the inching speed for the first 3 seconds
(“low” speed period). [Set range: 1 to +255]
(Coefficient. Set large number for higher speed.)