Promise Technology VTRAK E610f User Manual

VTrak E-Class Product Manual
396
Task 3: Making Initial Host Settings
After the packages and configuration file are installed, the Host is ready to accept
multipath settings.
Setting the Daemon to Run – RHEL 5, 5.1, 5.2, 5.3, and 5.4
This action requires RHEL installation with the “linux mpath” Option. See “Before
You Begin” on page 389.
To set the MP daemon to run at boot time:
1. Open a terminal window.
2. Verify that /etc/rc.d/rc[3~5].d/ has a symbolic link to
/etc/rc.d/init.d/multipathd. Also see the Note below.
Run the command:
# ls -al /etc/rc.d/rc[3~5].d/ | grep multipathd
3. If there is no symbolic link, run the command:
# cd /etc/rc.d/rc[3~5].d/
Then run the command:
# ln -s /etc/rc.d/init.d/multipathd S13multipathd
Note: /etc/rc.d/rc[3~5].d saves a link to start at each run level:
• Run level 3 is for a single user.
• Run level 4 is for multiple users.
• Run level 5 is for multiple users on X Windows.
Setting the Daemon to Run – SLES 10, 10 SP1, 10 SP2,
10 SP3, and 11
To set the MP daemon to run at boot time:
1. Open a terminal window.
2. Set the daemon to run at boot time.
# chkconfig multipathd on
The system does not return anything.
Verifying the Modules are Loaded
To verify that the DM-MP modules are loaded:
1. Open a terminal window.

Promise Technology VTRAK E610f Specifications

General

Brand	Promise Technology
Model	VTRAK E610f
Category	Storage
Language	English