Promise Technology VTRAK E610f User Manual

Chapter 5: Management with the CLU
245
Restarting the Subsystem
There are two methods for restarting the subsystem. Choose one of the following
procedures:
• Restarting the Subsystem (page 245)
• Restarting VTrak – SSH Connection (page 245)
• Restarting VTrak – Serial Connection (page 246)
Restarting VTrak – Telnet Connection
To restart the RAID subsystem:
1. From the Main Menu, highlight Additional Info and Management and press
Enter.
2. Highlight Shutdown or Restart and press Enter.
3. Highlight Option and press the spacebar to display Restart.
4. Highlight Submit and press Enter.
A warning message appears.
5. Press Y to continue.
The screen goes blank.
6. Wait about two minutes.
7. Re-establish your Telnet connection to the VTrak CLU.
See “Making a Telnet Connection” on page 167.
If you cannot re-establish a connection, wait 30 seconds and try again.
Restarting VTrak – SSH Connection
To restart the RAID subsystem:
1. From the Main Menu, highlight Additional Info and Management and press
Enter.
2. Highlight Shutdown or Restart and press Enter.
3. Highlight Option and press the spacebar to display Restart.
4. Highlight Submit and press Enter.
A warning message appears.
5. Press Y to continue.
Note
If you have a JBOD Expansion, you are not required to restart the
JBOD subsystems when you restart the RAID subsystem.

Promise Technology VTRAK E610f Specifications

General

Brand	Promise Technology
Model	VTRAK E610f
Category	Storage
Language	English