Promise Technology VTRAK E610f User Manual

Chapter 6: Maintenance
259
Replacing a Power Supply
The power supply and its fans are replaced as one unit. There are no individually
serviceable parts. No tools are required for this procedure.
Remove the Old Power Supply
To remove the power supply:
1. Verify that the power supply LED is amber or red.
2. Switch off the power.
3. Unplug the power cord.
4. Press the release button and pull the handle downward as shown. See
Figure 1 (E610f/s) or 2 (E310f/s).
5. Pull the power supply out of the VTrak enclosure.
Install a New Power Supply
To install the power supply:
1. Carefully slide the power supply into the enclosure.
2. Gently press the handle in and upward until it locks. See Figure 1 (E610f/s)
or 2 (E310f/s).
3. Plug in the power cord.
4. Switch on the power supply.
5. Verify that the new power supply LED is green.
Figure 1. Replacing an E610f/s power supply

Promise Technology VTRAK E610f Specifications

General

Brand	Promise Technology
Model	VTRAK E610f
Category	Storage
Language	English